Nautica Paths - Bay Networks NauticaRS Reference Manual

NauticaRS 5.5R Reference Guide

Nautica Paths

7-44
The attributes for a Nautica path are similar to those of an
Ethernet or PPP connection. To create a new Nautica path use the
following syntax:
[co] [new] pa nau/name
Where co takes the router into config mode (if required), new is
the new verb (Appendix A), pa takes you into the path object,
nau specifies the Nautica path type
user name assigned to the path.
To modify an existing nautica path, use the syntax above but
replace the new verb with the mod verb. mod is the MTD for the
modify verb (Appendix A). For example:
[co] [mod] pa nau/wat1
To remove a Nautica path from the router, use the same syntax but
replace the verb with the del verb. del is the MTD for the delete
verb (Appendix A). For example:
[co] [del] pa nau/wat1
When you modify or create a new Nautica path, the BCC moves
into the Nautica path object. Typing i at this prompt displays a list
of all the path attributes.
(page 7-5) and name is the
117237-E Rev.00