Bay Networks NauticaRS Reference Manual page 599

117237-E Rev.00
c:> marload marlin.ldr -boot -i[interrupt]
Where
[ interrupt ]
Note: The Windows 95 virtual packet driver uses interrupt 0x69
unless instructed otherwise in the SYSTEM.INI file.
6. Downloading router code using the packet driver
With the Marlin in bootmode ("Ready 4Mb" on the Front
Panel display), execute the following command from the
DOS prompt:
c:> marload marlin.bay
If your packet driver is not configured to use interrupt 0x66
(Step 1), issue the previous command with the optional
-i[interrupt] parameter:
c:> marload marlin.bay -i[interrupt]
Where [ interrupt ]
Note: The Windows 95 virtual packet driver uses interrupt 0x69
unless instructed otherwise in the SYSTEM.INI file.
While marload command is running, dots appear on the
screen to mark its progress. When the installation is complete
"BURN" is displayed on the Front Panel display.
It is now safe to reboot the unit.
7. Downloading router code using Nautica Wizard
After downloading the new bootloader, reboot the Marlin.
From a Windows 95 or NT workstation, use Nautica Wizard
to download the new router code.
a. Select the unit to be configured in the Nautica Wizard
window by clicking on it once.
b. Select File > Download New Router Software.
Upgrading from NauticaRS 3.5R
is the interrupt required, 0x66.
is the interrupt required, 0x66.
Appendix B-11