Bay Networks NauticaRS Reference Manual page 443

Parameter:
MTC:
Default:
Options:
Function:
Instructions:
Parameter:
MTC:
Default:
Options:
Function:
Instructions:
117237-E Rev.00
all-protocols
al
no
no, yes
Allows or disallows the passing of unknown protocols
through the NAT gateway.
Change this value to yes to allow the passing of
unknown protocols.
default-addr
de
0.0.0.0
A valid IP address
Leaving this at the default of 0.0.0.0 directs new
incoming NAT connections to the router. This allows
Telnet, SNMP and HTTP access to the router from the
public network via the single NAT address.
Changing the IP address here diverts new incoming NAT
connections to this IP address. This may be useful if you
want all incoming connections to be mapped to your
workstation; but it takes effect for all TCP & UDP paths.
This can cause problems if remote managers need to get
into the NAT router for configuration purposes (they are
directed to the new IP address, not the router itself).
If you want to direct specific protocols to specific IP
addresses, use static NAT entries
Leave the default value, or enter an IP address to which
new incoming NAT connections are diverted.
Setting Up NAT
(page 15-5).
15-3