Startnseñactivate Ethernet Lan Support; Stopnseñde-Activate Ethernet Lan Support - Nortel Meridian Meridian 1 Maintenance Manual

startNSEÑactivate Ethernet LAN support
This command allows you to invoke the networking feature based on the
Network Service Extension (NSE) software package. It provides remote
access to the Application Module or IPE Module from a PC using the telnet
utility, and transfers files from a PC to the Application Module or IPE
Module using the ftp utility.
To activate the networking feature, Ethernet LAN support must have been
enabled using a keycode (refer to Procedure 25: Enable or disable Ethernet
LAN support).
Note: Ensure that you have the Application Module or IPE Module
connected to the Ethernet with a cable before you run startNSE.
Example:
maint> startNSE
Enter the Node Name: host1
Enter the Node Address: 12.210.67.89
Restart the system? y
You can choose to reboot the system at this point by typing y, or you can
defer the reboot by typing n.
stopNSEÑde-activate Ethernet LAN support
This command stops Ethernet LAN support and returns the system to its
original status before NSE was started. It also prevents an Ethernet LAN-
based PC from gaining access to the applications.
Example:
maint> stopNSE
Restart the system?
You can choose to reboot the system at this point by typing y, or you can
defer the reboot by typing n.
Meridian Link Release 5C/CCR Release 3C Diagnostic and Maintenance Guide
Chapter 2: Application Module commands 79