Nortel Meridian Meridian 1 Maintenance Manual page 445

Procedure 21: Reboot and go through setup (continued)
Figure 102
System autoboot messages 2
This machine has not been used as a customer machine yet.
follow are from checking the built-in file systems for damage that might have
occurred during shipment.
all is well. If either message does come out, call your service
representative.
However, the machine is still usable unless you are told otherwise.
Checking file systems:
/dev/root
File System: root Volume:
** Phase 1 - Check Blocks and Sizes
** Phase 2 - Check Pathnames
** Phase 3 - Check Connectivity
** Phase 4 - Check Reference Counts
** Phase 5 - Check Free List
1992 files 27376 blocks 31684 free
/dev/usr
File System: usr Volume:
** Phase 1 - Check Blocks and Sizes
** Phase 2 - Check Pathnames
** Phase 3 - Check Connectivity
** Phase 4 - Check Reference Counts
** Phase 5 - Check Free List
2861 files 44730 blocks 327360 free
Node name set to sysV68.
Welcome!
This machine has to be set up by you.
followed by the RETURN key.
those things that should be done the "first time" the machine is used.
Until you do so, the above filesystem shipment damage check will be run
each time you boot.
mount -f S51K /dev/usr /usr
Checking for system dump ...
Expreserve notification performed.
Error logging started.
Stream Error logging started.
netspec "tcpip" not set up.
Line printer scheduler started.
The system is ready.
Console Login:
2 At the ÒConsole Login:Ó prompt, type root and press [Return] to log
in as the root user.
3 At the ÒPassword:Ó prompt, press [Return].
The root password is reset once the application is installed.
Meridian Link Release 5C/CCR Release 3C Diagnostic and Maintenance Guide
Chapter 8: Recovery/replacement procedures 433
As long as you do not see either of the messages
BOOT SYSV68
or
FILE SYSTEM WAS MODIFIED
R3
R3
When you see the "login" message type
setup
This will start a procedure that leads you through
The messages that