Nortel Meridian Meridian 1 Maintenance Manual page 101

Table 3
Link maintenance commands
Command
enable link link#
disable link link#
status link link#
get links
display linkctl
change linkctl
read linkctl filename
save linkctl filename
display link link#
change link link#
save link link# [filename]
read link link# [filename]
statistics link link#
get associations
get dn association_id
get resource association_id
Meridian Link Release 5C/CCR Release 3C Diagnostic and Maintenance Guide
Chapter 3: Link maintenance commands 89
Description
puts link in enabled state
puts link in disabled state
displays status of link
displays all configured links
displays contents of link control file
allows you to change entries within link
control file
reads the contents of specified link
control file into memory
saves link control information to file
specified
displays current link configuration
parameters
allows you to change link configuration
parameters
saves link parameters to file specified
reconfigures a link from parameters
saved in a file
generates a protocol-specific list of
statistics for link number specified
displays information on current
associations (Meridian Link only)
displays DNs registered for specified
association (Meridian Link only)
displays Meridian 1 resources acquired
for specified association (Meridian Link
only)
Ñ continued Ñ
Applies to
Links 0, 1, and 2
Links 0, 1, and 2
Links 0, 1, and 2
Links 0, 1, and 2
Links 0, 1, and 2
Links 0, 1, and 2
Links 0, 1, and 2
Links 0, 1, and 2
Links 0, 1, and 2
Links 0, 1, and 2
Links 0, 1, and 2
Links 0, 1, and 2
Links 0, 1, and 2
Applications
Applications
Applications