Nortel Meridian Meridian 1 Maintenance Manual page 235

This specifies (in 1/10 second increments) the amount of
T13
time the application will wait for an X.25 Clear Confirmation
packet after sending an X.25 Clear Request packet to the host
(T23 for DTE).
This specifies (in 1/10 second increments) the amount of
T14
time the application will wait for a packet with any P(R) value
after sending an X.25 Data packet to the host (T24 for DTE).
This specifies (in 1/10 second increments) the amount of
T15
time the application will wait for a packet with a P(R) value that
acknowledges a transmitted X.25 Data packet to the host (T25 for
DTE).
This specifies (in 1/10 second increments) the amount of
T16
time the application will wait for an X.25 Interrupt Confirmation
packet after sending an X.25 Interrupt Request packet to the host
(T26 for DTE).
Maximum T12 Retries
times the application will send Reset Requests due to T12 time
outs (R12 for DCE and R22 for DTE).
Maximum T13 Retries
times the application will send Clear Requests due to T13 time
outs (R13 for DCE and R23 for DTE).
6 Have the host computer programmer verify the X.25 call request
packet format as follows:
¥ The Called DTE address must match the address specified in the
Host Link (Link 1) configuration file.
¥ No facilities should be specified.
¥ No user data should be specified.
7 Check the physical DTE/DCE configuration.
If the host computer is physically DTE, the Host Link port on the IPE
Module or MVME705B transition card (SP3) in the Application
Module must be configured as DCE (this is the default). If the host
computer is configured as DCE, the IPE Module or transition card
must be configured as DTE.
Meridian Link Release 5C/CCR Release 3C Diagnostic and Maintenance Guide
Chapter 4: Diagnosing faults 223
This specifies the maximum number of
This specifies the maximum number of