Nortel Meridian Meridian 1 Maintenance Manual page 422

410 Chapter 8: Recovery/replacement procedures
553-3211-510 Standard 1.0 October 1998
Procedure 19: Load the operating system tape on an Application
Module with an MVME147 card (continued)
Note: Phases 3 and 4 may take from 30 to 90 minutes to complete.
Figure 67
BOS installation, phases 3 and 4
***> Checking tape in drive
Phase 3. Prepare Installation Disk Drive(s)
***> Retensioning tape (in background)
***> Formatting root file systemÕs disk drive
***> Writing slice table to /dev/rdsk/m147_00s7
***> Creating the root file system
***> Labeling the root file system
***> Creating the usr file system
***> Labeling the usr file system
***> Installing boot-loader on root file systemÕs disk drive
***> Mounting root file system as /root
***> Making the /tmp directory
***> Making the /usr directory
***> Mounting usr file system as /root/usr
Phase 4. Install BOS Software
***> Waiting for tape to complete retensioning
***> Copying files; this will take from 10-35 minutes
depending upon your system configuration...
70240 blocks
1200 blocks
10960 blocks
40 blocks
***> Making the root file system lost+found directory
Reserving 160 entries
***> Making the usr file system lost+found directory
Reserving 480 entries
***> Installing /etc/badtracks/m147_00 bad spot list
***> Creating sysadm(1M) package information file
***> Setting up the new operating system
***> Creating root and usr file system associated device nodes
***> Setting permissions on installation diskÕs root directory
***> Running mkcomply to confirm correct installation
***> Setting rootÕs password entry
New password:
32 At the ÒNew Password:Ó prompt, press [Return].
33 The system responds with ÒRe-enter new password:Ó. Press
[Return] again.