Nortel Meridian Meridian 1 Maintenance Manual page 307

090A - Enable link command failed
Application Module cannot enable link 0 (AML) or link 1 (host link).
There are a number of possible reasons for this error. First, the X.25
software may not be installed on the Meridian Link Module or the
X.25 software may not be installed correctly. Second, the Meridian
Link software may not be installed correctly. Third, the MVME333-2
XCC card may be bad.
Reboot the Meridian Link Module and invoke the Meridian Link
software. If the problem persists, try to reinstall the X.25 and Meridian
Link software and restart the Meridian Link software. If the problem
still persists, replace the MVME333-2 XCC card.
090B - Disable link command failed
Application Module cannot disable link 0 (AML) or link 1 (host link).
There are a number of possible reasons for this error. First, the X.25
software may not be installed on the Meridian Link Module or the
X.25 software may not be installed correctly. Second, the Meridian
Link software may not be installed correctly. Third, MVME333-2
XCC card may be bad.
Reboot the Meridian Link Module; and invoke the Meridian Link
software. If the problem persists, try to reinstall the X.25 and Meridian
Link software and restart the Meridian Link software. If the problem
still persists, replace the MVME333-2 XCC card.
090C - Link command not supported
A link command used is not supported. Refer to Chapter 3, ÒLink
maintenance commandsÓ for valid commands.
090D - Link statistics request failed
The statistics command for a link only operates if the link is up. Ensure
that the link is up before entering a statistics request.
090E - Configuration data overflow
The configuration data file is too large. Restart the Meridian Link
software.
Meridian Link Release 5C/CCR Release 3C Diagnostic and Maintenance Guide
Chapter 6: Link error messages 295