Nortel Meridian Meridian 1 Maintenance Manual page 265

Table 7
maint messages that appear on the console (continued)
Command Message
langconfig Error: secondary language cannot
(continued) be the same as the default
language. Select again.
Incorrect input -- select again.
Error: need to define environment
variable: CCRUSR_HOME_PATH
Error: need to define environment
variable: MAINT_HOME_PATH
mlexit (no error messages)
mlstart (no error messages)
portconfig Invalid port #
Bad state...try again
CanÕt change STATE....Printer
defined on this port (delete printer
first)
Bad baud rate...try again
Cannot define printer on this port
(Use the portconfig command to
change state of this port to off
first.)
powerdown (no error messages)
Meridian Link Release 5C/CCR Release 3C Diagnostic and Maintenance Guide
Chapter 5: Application Module and IPE Module error messages 253
Ñ continued Ñ
Description
The secondary language must be
different from the primary language.
A valid secondary language was not
entered.
The language configuration file is
corrupted.
The language configuration file is
corrupted.
Port numbers are 1 through 8 for
the CCR application.
Valid port states are on (for a
terminal) or off (for a printer).
Cannot change state to on if a
printer has already been defined.
Delete the printer using the
printconfig command if installing a
terminal.
Baud rates can be 1200, 2400, or
9600.
Cannot add a printer if a port has
already been defined. Delete the
port using the portconfig command
if installing a printer.