260 Chapter 5: Application Module and IPE Module error messages
Other messages that appear on the system console
Table 9
display messages that appear on the console
Message
display: can't open file 'filename'
Table 10
SysLog messages that appear on the console
Message
syslog: could not open named
pipe
syslog: write to System Log
failed
553-3211-510 Standard 1.0 October 1998
The messages in this section may appear on your system console at any
time. These error, warning, or status messages, appear as a result of lower-
level software processes.
display
The following messages appear as a result of some display activities.
Description
The specified file was not available. Because that
display takes file name input from other application
processes, check the spelling of the file name you
entered for the previous command and try entering it
again.
SysLog
The following messages appear as a result of processes related to the
SysLog file.
Description
ErrorÑthe named pipe used for error collection from
the various processes could not be opened. Use
Procedure 2: SBC restart.
WarningÑa failure has occurred while attempting to
write to the SysLog file, most likely because the file
system is too full to support the file. If this condition
occurs, all messages intended for the SysLog file
should be written to the console. Use the diskuse
command to check the utilization of the hard disk.
Ñ continued Ñ