Nortel Meridian Meridian 1 Maintenance Manual page 471

Procedure 24: Restore configuration files and data files from the
backup tape (continued)
Figure 154
Rstdata messages screen 3
Starting restore
x 4k of
x 4k of
x 4k of
x 4k of
x 4k of
x 4k of
x 4k of
x 4k of
x 4k of
x 4k of
x 4k of
x 4k of
x 4k of
x 4k of
x 4k of
x 4k of
x 6k of
x 4k of
Restore successful
Configuration changed, restarting link processes.
Configure Link 0 :
Configure Link 1 :
Configure Link 2 :
Enable Link 0 :
Enable Link 1 :
Enable Link 2 :
Link 0 : enabled but down
Link 1 : enabled but down
Link 2 : enabled but down
Link 0 : up
Link 1 : up
Link 2 : up
Application release successful
9 If, in step 6, you stopped any applications, you are prompted to
restart them. Type y and press [Return] to restart the applications.
10 Unlock the tape drive and remove the cassette tape. Keep this, and
label it with the date, and store it with all your backup tapes in a
safe place in case you need to use it again.
Meridian Link Release 5C/CCR Release 3C Diagnostic and Maintenance Guide
Chapter 8: Recovery/replacement procedures 459
6k [1] usr/maint/files/AMprofile
10k [1] /usr/maint/files/AutoStart
14k [1] /usr/maint/files/IncrDY
18k [1] /usr/maint/files/IncrTM
22k [1] /usr/maint/files/Port
26k [1] /usr/maint/files/Prefs
30k [1] /usr/maint/files/Speed
34k [1] /usr/maint/conf/hdlchlnk.dataf
38k [1] /usr/maint/conf/hdlcmlnk.dataf
42k [1] /usr/maint/conf/lh.config
46k [1] /usr/mlusr/conf/loop13DCE.d
50k [1] /usr/mlusr/conf/loop13DTE.d
54k [1] /usr/mlusr/conf/loop31DCE.d
58k [1] /usr/mlusr/conf/loop31DTE.d
62k [1] /usr/mlusr/conf/tscfg.datafile
66k [1] /usr/mlusr/conf/vlink.datafile
72k [1] /usr/mlusr/conf/x25bcf333.2
76k [1] /usr/mlusr/conf/x25hlink.datafi
successful
successful
successful
successful
successful
successful