Maint Messages - Nortel Meridian Meridian 1 Maintenance Manual

maint messages

Table 7
maint messages that appear on the console
Command Message
ÔcommandÕ is not a valid command
command is ambiguous, could be
one of the following:
no qualified commands found,
canÕt execute
admin (no error messages)
applconfig Incorrect input form, please try
again
applexit (no error messages)
Meridian Link Release 5C/CCR Release 3C Diagnostic and Maintenance Guide
Chapter 5: Application Module and IPE Module error messages 243
The following is a summary of the messages (errors and warnings)
displayed on the console while you are using maint commands. In any case
where it is likely that the application software has not been installed
successfully, reinstall the application software using the reinstallation
procedure.
Ñ continued Ñ
Description
The command you entered was not
valid. Check the spelling of the
command and try entering it again.
Make sure CAPS LOCK is not set.
You entered a short form of a
command and the short form could
apply to more than one command.
Enter the command again in a form
that is not ambiguous.
The system is defective. Reload the
system.
The input for the application
parameter is not within the accepted
range. Enter a value according to
the range indicated in the prompt.