Nortel Meridian Meridian 1 Maintenance Manual page 451

Procedure 21: Reboot and go through setup (continued)
16 When prompted, type the minutes and press [Return].
Figure 115
Date and time set prompt
Date and time will be set to:
17 You are prompted to confirm the date and time. Type y and press
[Return].
Once the application starts, the time will be set to the time on the
Meridian 1. The system response reflects any time or time zone
change with a Òcron abortedÓ message.
Figure 116
Time change confirmation
Sat Sep 18 11:19:00 EDT 1993
The date and time are now changed.
cron aborted: SIGTERM
The cron has been restarted to pick up the new time and/or time zone.
The next step is to set up logins.
The first one you make should be for yourself.
Anytime you want to quit, type "q".
If you are not sure how to answer any prompt, type "?" for help,
or see the AdministratorÕs Guide.
If a default appears in the question, press <RETURN> for the default.
Note: Ensure that you respond with q to the remaining prompts.
Entering any other data may prevent applications from functioning
properly.
Figure 117
UserÕs name prompt
Enter userÕs full name [?, q]:
18 You are prompted to enter a user login name. Type q and press
[Return].
Meridian Link Release 5C/CCR Release 3C Diagnostic and Maintenance Guide
Chapter 8: Recovery/replacement procedures 439
6/29/93 09:37. OK? [y, n, q]