Procedure 8: Configure The Application Module Mvme147 Sbc Card - Nortel Meridian Meridian 1 Maintenance Manual

Procedure 8: Configure the Application Module MVME147
SBC card
MVME147 SBC cards may be shipped with the battery backed-up RAM
(BBRAM) values set to their original factory defaults. To set the BBRAM
information for use with the Application Module, follow the procedure
described below.
Do not press the [Backspace] or [Delete] key when the operating
system is not installed, or you may drop out of the procedure into a
previous menu or out of the installation procedure altogether. Use #
(hold the [Shift] key and press 3) to backspace.
If you drop out of the procedure (into the Ò#Ó prompt), start the
reinstallation procedure from the beginning.
This procedure assumes that you have completed Procedures 1 and 3, and
you have just installed a new MVME147 SBC card using Procedure 7.
1 Set the MPDU circuit breaker to ON (up).
The following screen appears.
Figure 20
System restart messages (MVME147 card)
Copyright Motorola Inc. 1989,1990, All Rights Reserved
VME147 Monitor/Debugger Release 2.42 - 8/1/94
CPU running at 25 MHz
FPC passed test
MMU passed test
COLD Start
Onboard RAM start = $00000000, stop = $007FFFFF
No offboard RAM detected
2 When messages begin to appear, type h.
Meridian Link Release 5C/CCR Release 3C Diagnostic and Maintenance Guide
Chapter 8: Recovery/replacement procedures 373
ATTENTION