Connect And Verify Lan Connections - Nortel CallPilot Install Manual

68 Chapter 5 Install and configure the High Availability pair
30
31
32

Connect and verify LAN connections

Use the following figure and procedure to connect the HB1, HB2, and
MIRROR crossover LAN cables, and the ELAN and CLAN cables between
the two High Availability servers.
Figure 25
Rear panel of 1005r server showing LAN connections
Copyright © 2007, Nortel Networks
.
d. Enter IP information for the HB1, HB2, and MIRROR network
interfaces cards.
The following table shows the suggested default values for HB1,
HB2, and MIRROR on CP2. If you do not use these suggested
values, ensure that you use your new values throughout the
configuration.
Network Interface Card
(NIC)
Heartbeat 1 (HB1)
Heartbeat 2 (HB2)
MIRROR
Click Next.
Result: The Ready to Configure page appears.
Click Finish to start process.
Result: The system starts the configuration process and displays
its progress.
After the process is complete, restart the CallPilot server.
Nortel CallPilot
High Availability: Installation and Configuration
NN44200-311 01.06 Standard
5.0 15 May 2007
IP Address
192.0.0.11
194.0.0.11
193.0.0.11
—End—
Subnet Mask
255.255.255.0
255.255.255.0
255.255.255.0