Nortel Meridian Meridian 1 Maintenance Manual page 458

446 Chapter 8: Recovery/replacement procedures
553-3211-510 Standard 1.0 October 1998
Procedure 22: Load the application software from tape (continued)
Figure 131
Keycode prompt 3
Keycode group 3 (or Q or q to quit):
13 You are prompted for the third group of keycode characters. Type
the third group and press [Return].
Figure 132
Keycode prompt 4
Keycode group 4 (or Q or q to quit):
14 You are prompted for the fourth group of keycode characters. Type
the fourth group and press [Return].
Figure 133
Keycode prompt 5
Keycode group 5 (or Q or q to quit):
15 You are prompted for the fifth group of keycode characters. Type
the fifth group and press [Return].
A list of configured applications appears.
Note: Optional feature prompts will not appear if the features were
not configured in the keycode. For example, if Meridian Link was not
purchased, the prompts in Figures 134, 135, and 136 will not appear.
Figure 134
Meridian Link protocol prompt
Please enter the Meridian Link protocol, x for X.25, <cr> for TCP/IP): <cr>