Nortel Meridian Meridian 1 Maintenance Manual page 421

Procedure 19: Load the operating system tape on an Application
Module with an MVME147 card (continued)
29 You are prompted to indicate whether you wish to install online
problem descriptions. Nortel does not use these descriptions. Type
n and press [Return] to indicate no.
Figure 65
Verify installation prompt
---> Do you want to verify correct installation? (y, n, q) [y]:
30 You are prompted to verify correct installation. Press [Return] to
indicate yes.
Confirmation of your selection appears, along with a summary of
the installation information. The summary should look exactly like
Figure 66, with the possible exception of the disk drive entry
(Ôm147fuj2614Õ).
Figure 66
Software installation summary
Selected to run mkcomply to verify correct installation.
Check the information below.
the previous questions will have to be answered again.
* Format and install the new bootloader on the MVME147,
controller #0, disk drive #00,
using the ddefs(1M) description Ôm147fuj2614Õ.
* Create a root file system using 1 Kbyte logical blocks
on slice 0 on the MVME147, controller #0, disk drive #00.
* Create a swap area in slice 1 on the
MVME147, controller #0, disk drive #00.
* Create a usr file system using 1 Kbyte logical blocks
on slice 2 on the MVME147, controller #0, disk drive #00.
* Install On-line Manual Pages Object Package (OLMP).
* Do Not Install On-line Problem Descriptions (Tars on Tape)
---> Is all of this information correct (y, n, q, ?):
31 If the summary information is correct, type y and press [Return]. If it
is not correct, type n, press [Return], and then enter the information
correctly when prompted.
When the information is correct and you reply y to the above
prompt, phases 3 and 4 of the installation begin.
Meridian Link Release 5C/CCR Release 3C Diagnostic and Maintenance Guide
Chapter 8: Recovery/replacement procedures 409
If any part of the information is incorrect,