Nortel Meridian Meridian 1 Maintenance Manual page 306

294 Chapter 6: Link error messages
553-3211-510 Standard 1.0 October 1998
0903 - Link ID Already Exists
To rectify this problem, reboot the module.
0904 - Meridian 1 or host machine name already exists
mlusr attempted to configure a link with an existing name. Use a
different name.
0905 - Bad Link ID
The link ID is out of range. An invalid (unconfigured) link number
was specified in a link command (enable, disable). Use get links to get
a list of valid links.
If the application software is not functioning correctly, shut down the
application (including the Meridian Link software) and restart it.
0906 - Link Already Enabled
mlusr attempted to enable an already enabled link. No action is
necessary.
0907 - Link Already Disabled
mlusr attempted to disable an already disabled link. No action is
necessary.
0908 - Error in opening a trace file
The trace file cannot be opened. Use the diskuse command to check
the amount of memory space available or try another name.
0909 - Link Configuration Fail
Meridian Link Module can't configure link 0 (AML), link 1 (host link),
or link 2 (Meridian Mail link).
There are a number of possible reasons for this error. First, the X.25
software may not be installed on the Meridian Link Module or it may
not be installed correctly. Second, the Meridian Link software may not
be installed correctly. Third, the MVME333-2 XCC card may be bad.
Reboot the Meridian Link Module and invoke the Meridian Link
software. If the problem persists, try to reinstall the X.25 and Meridian
Link software and restart the Meridian Link software. If the problem
still persists, replace the MVME333-2 XCC card.