Procedure 18: Replace Or Reconfigure The Application Module Mvme705B Transition Card - Nortel Meridian Meridian 1 Maintenance Manual

392 Chapter 8: Recovery/replacement procedures
Procedure 18: Replace or reconfigure the Application
Module MVME705B transition card
Table 19
MVME705B jumper settings and cable connections
Serial DCE mode
port
SP1 On header K6, place jumpers over
pins 3-4, 7-8, 9-10
Plug the I/O cable into P14
SP3 On header K5, place jumpers over
pins 3-4, 7-8, 9-10
Plug the I/O cable into P12
SP5 Not used
553-3211-510 Standard 1.0 October 1998
You must remove the Application Module from the AEM to access the
transition cards.
1 Complete Procedure 13: Remove the Application Module.
2 Loosen the screws at the top and bottom of the card faceplate (at
the rear of the Application Module).
3 Pull the card out of the Application Module.
4 Disconnect the ribbon cable to the card.
5 Check the jumpers and cable connections on the replacement card
or change the settings on the current card to reconfigure it. See
Table 19 and Figure 39.
6 Connect the ribbon cable to the replacement or reconfigured card.
7 Slide the replacement or reconfigured card into the back of the
Application Module. Firmly press the middle of the faceplate to seat
the card.
8 Install the screws on the faceplate of the card.
9 Complete Procedure 14: Replace the Application Module, to
reinstall the module.
DTE mode
On header K6, place jumpers over
pins 1-2, 5-6
Plug the I/O cable into P13
On header K5, place jumpers over
pins 1-2, 5-6
Plug the I/O cable into P11
Not used