Procedure 10: Replace The Application Module - Nortel Meridian Meridian 1 Maintenance Manual

382 Chapter 8: Recovery/replacement procedures

Procedure 10: Replace the Application Module

MVME333-2 XCC card
553-3211-510 Standard 1.0 October 1998
1 Complete Procedure 3: Hardware powerdown.
2 Loosen the screws at the top and bottom of the card.
3 Use the ejectors to unlock the card.
4 Pull the card out of the Application Module.
5 Check the jumpers on the replacement card (see Table 16).
6 Slide the replacement unit into the Application Module. Firmly press
the middle of the faceplate to seat the card.
7 Tighten the screws on the faceplate of the replacement card.
8 Restart power to the Application Module.
Table 16
MVME333-2 XCC card jumper settings
Block
K1
K2
K3
K4
K5
K6
K7
K8
K9
Jumper setting
2 and 4, 6 and 8, 10 and 12, 13Ð14, 15Ð16, 23Ð24
none
1Ð2, 5Ð6, 7Ð8, 9Ð10
none
1Ð2, 3Ð4
5Ð6
5Ð6
none
1Ð2