Installing And Connecting An Ethernet Cable; Cabinet System: Ip Expansion 10Baset Port - Nortel Meridian 1 Succession 1000M Installation And Configuration Manual

Installing and connecting an Ethernet cable

Cabinet system: IP expansion 10BaseT port

Installing and connecting SDI and Ethernet ports
This section describes the procedures required to connect an Ethernet cable
to:
• a Cabinet system (Procedure 45 on
• a Chassis system (Procedure 46 on
The Cabinet system provides one 10 Mbps Ethernet connection to a Local
Area Network (LAN). The Ethernet cable connector is located just left of the
retaining bar in the main and IP expansion cabinets as shown in Figure 117
on page 288. The 10BaseT Ethernet port available on the SSC of an IP
expansion cabinet is functional. However, the Ethernet port on the IP
expansion cabinet does not have a default IP configuration. This means that
the IP port configuration must be performed before it can be used.
page 290)
page 292)
Small System Installation and Configuration
Page 287 of 562