Nortel Meridian Meridian 1 Maintenance Manual page 318

306 Chapter 7: CCR log file messages
Messages
553-3211-510 Standard 1.0 October 1998
The log file provides brief information on each message. The following
section provides a more thorough explanation of the messages (listed in
message number order), the impact of the event or error, and where
possible, a strategy for recovery. If a problem persists, contact your Nortel
support personnel.
Some messages are accompanied by parameters that help pinpoint the
location and possible cause for the event. In this section, optional
parameters (those that are only reported in certain situations) are
surrounded by square brackets ([Script name], for example). Cause
parameters (shown as a number in the log file message) are described in
more detail here.
1001
Log message
None
Parameters
The application could not complete the validation as not
Description
enough memory was available to allocate.
Not enough memory was available for complete validation.
Impact
The script being compiled cannot be used without changes.
If large lists of constants (for example, specific ACD DNs)
Recovery
are used in the script, try to define these as variables rather than
constants. This decreases compiler memory use. If the system is very
busy (many calls active, many scripts installed), try compiling the
script during a quieter time. Otherwise, make the script smaller.
Compiler out of memory