Conshareñmeridian 1 Console Session - Nortel Meridian Meridian 1 Maintenance Manual

conshareÑMeridian 1 console session
Use the conshare command to pass through to the Meridian 1 interface and
conduct a maintenance session from your maint login session.
The Application Module or IPE Module is optionally cabled to a
Meridian 1 SDI port. Initially, you will be prompted to confirm whether the
SDI port is correctly configured. The SDI port must be configured as TTY
(DTE) and at 2400 baud rate.
Next, you will be prompted to specify the Application Module or IPE
Module port that is cabled to the SDI port. The default for the Application
Module is /dev/tty02, which represents the third port on the MVME712
transition card (connector J8 on the back of the I/O subpanel, SDI LINK on
the universal I/O panel, or card 1 conn 3 on the generic I/O panel). The
default for the IPE Module is /dev/tty03, which represents port 3 of the IPE
Module.
Note: Meridian 1 accepts messages sent in uppercase only; the
Application Module or IPE Module accepts messages sent in mixed
case. Therefore, you must set CAPS LOCK before starting a session.
Be sure to unset CAPS LOCK when returning to the Application
Module or IPE Module, or your output will appear distorted.
Type
<control>\C
of help options, type
Note: In the following example,
[Return].
Meridian Link Release 5C/CCR Release 3C Diagnostic and Maintenance Guide
Chapter 2: Application Module commands 45
to get back when the session is finished. To display a list
.
<control>?
<cr>
indicates where you press