Record Commands - Nortel Meridian Meridian 1 Maintenance Manual

record commands

Five record commands enable you to control recording of specified
messages flowing across the link for an association. The messages are
recorded in hexadecimal format to files on the Application Module or IPE
Module hard disk (see Figure 10). The commands are as follows:
¥ set record
¥ enable record
¥ disable record
¥ clear record
¥ get record
Type help msgtypes and press [Return] to see a list of all message types
that can be selected in the messages parameter. You can also type help
messages and press [Return] to see a list of message types supported up to
Meridian Link Release 5C software.
Use the view command (described later in this chapter) to look at record
files, which use the format rec_xxx.yyy; where xxx is a number starting at
000 for the first file and incrementing by 1 for each new file, and yyy is the
association ID of the application for which messages are being recorded.
A new file is created whenever an enable recording command is given. A
new file is also created when the rec_xxx.yyy file exceeds 100 kbytes.
Meridian Link Release 5C/CCR Release 3C Diagnostic and Maintenance Guide
Chapter 3: Link maintenance commands 129