Nortel Meridian Meridian 1 Maintenance Manual page 408

396 Chapter 8: Recovery/replacement procedures
553-3211-510 Standard 1.0 October 1998
Procedure 19: Load the operating system tape on an Application
Module with an MVME147 card (continued)
Figure 41
Start-up interrupt menu
1) Continue System Start-up
2) Select Alternate Boot Device
3) Go To System Debugger
4) Initiate Service Call
5) Display System Test Errors
6) Dump Memory to Tape
Enter Menu #:
4 The menu in Figure 41 appears. Type 3 and press [Return] to enter
the system debugger.
5 At the Ò147-Diag>Ó prompt, type iot;t and press [Return].
The system performs a scan of disk/tape controllers (Figure 42).
Figure 42
Results of disk/tape controller scan
Scanning system for available disk/tape controllers........
Disk Controllers Available
LUN Type Address
0 VME147 $FFFE4000
1 VME147 $FFFE4000
VME147 $FFFE4000
Align LUNs to SCSI addresses [Y,N] N?
6 Write down the type of disk drive installed in SCSI address 0. This
information is required later in the procedure. (In the example
shown above, the drive is a Fujitsu M2614S.)
7 You are prompted to align LUNs. Type y and press [Return].
Figure 43
Disk/tape controller list after aligning LUNs
Disk Controllers Available
LUN Type Address
0 VME147 $FFFE4000
1 VME147 $FFFE4000
2 VME147 $FFFE4000
3 VME147 $FFFE4000
4 VME147 $FFFE4000
5 VME147 $FFFE4000
6 VME147 $FFFE4000
VME147 $FFFE4000
Save map in NVRAM [Y,N] N?
# dev
1 SCSI Addr = 0 - FUJITSU
1 SCSI Addr = 4 - TEAC
* SCSI Addr = 7
# dev
1 SCSI Addr = 0 - FUJITSU
1 SCSI Addr = 1
1 SCSI Addr = 2
1 SCSI Addr = 3
1 SCSI Addr = 4 - TEAC
1 SCSI Addr = 5
1 SCSI Addr = 6
* SCSI Addr = 7
M2614S M606
MT-2ST/N50 RV F
M2614S M606
MT-2ST/N50 RV F