Nortel Meridian Meridian 1 Maintenance Manual page 387

Procedure 8: Configure the Application Module MVME147 SBC card
(continued)
Figure 23
Disk/tape controller list after aligning LUNs
Disk Controllers Available
LUN Type Address
0 VME147 $FFFE4000
1 VME147 $FFFE4000
2 VME147 $FFFE4000
3 VME147 $FFFE4000
4 VME147 $FFFE4000
5 VME147 $FFFE4000
6 VME147 $FFFE4000
VME147 $FFFE4000
Save map in NVRAM [Y,N] N?
8 The LUN results appear. Type y and press [Return] to save the map
in non-volatile memory.
9 At the Ò147-Diag>Ó prompt, type ab and press [Return] to set
autoboot enable.
Autoboot enable prompts appear. Answer them as indicated below.
Figure 24
Autoboot enable prompts
Controller LUN = 00?
Device LUN = 00?
Default String =
Boot at Power-up only or any board Reset [P,R] = P?
On any board Reset:
Auto Boot from Controller 0, Device 0
10 At the Ò147-Diag>Ó prompt, type reset and press [Return].
The SCSI bus reset prompts appear. Answer them as indicated
below.
Figure 25
SCSI bus reset prompts
Reset Local SCSI Bus (Y, N)
Automatic reset of known SCSI Buses on RESET (Y, N) = N?
Cold/Warn Reset flag (C, W) = C?
Execute Soft Reset (Y, N)
Meridian Link Release 5C/CCR Release 3C Diagnostic and Maintenance Guide
Chapter 8: Recovery/replacement procedures 375
# dev
1 SCSI Addr = 0 - CDC
1 SCSI Addr = 1
1 SCSI Addr = 2
1 SCSI Addr = 3
1 SCSI Addr = 4 - TEAC
1 SCSI Addr = 5
1 SCSI Addr = 6
* SCSI Addr = 7
<cr>
<cr>
<cr>
?
y <cr>
N?
<cr>
<cr>
N?
ST1126N 9204
MT-2ST/N50 RV D
r <cr>
y <cr>