Nortel Meridian Meridian 1 Maintenance Manual page 388

376 Chapter 8: Recovery/replacement procedures
553-3211-510 Standard 1.0 October 1998
Procedure 8: Configure the Application Module MVME147 SBC card
(continued)
11 At the Ò147-Diag>Ó prompt, type env and press [Return].
The environment prompts appear.
12 Answer the prompts as indicated in Figures 26, 27, or 28,
depending on the firmware installed in your system. The firmware
release appeared in the start-up messages shown in step 3.
Figure 26
Environment prompts for firmware revision 2.2
Bug or System environment [B,S] = S?
SYSTEM V/68 or VERSAdos operating system [S,V] = S?
Execute/Bypass SST Memory test [E,B] = E?
Set VME Chip:
Board ID [0-FF] = $00?
GCSR base address [0-0F] = $0F?
Utility Interrupt Mask [0-FE] = $00?
Utility Interrupt Vector [$20-$30] = $0180?
Figure 27
Environment prompts for firmware revision 2.3
Bug or System environment [B,S] = S?
Execute/Bypass System Memory Sizing [E,B] = B?
Execute/Bypass SST Memory test [E,B] = B?
Set VME Chip:
Board ID(def is 0) [0-FF] = $00?
GCSR base address offset(def is 0F) [0-0F] = $0F?
Utility Interrupt Mask(def is 0) [0-FE] = $00?
Utility Interrupt Vector number(def is 60) [8-F8] = $60?
VMEbus Interrupt Mask(def is FE) [0-FE] = $FE?
s <cr>
b <cr>
<cr>
<cr>
<cr>
<cr>
<cr>
<cr>
<cr>
<cr>
<cr>
<cr>
<cr>
<cr>
<cr>