Change Linkctl - Nortel Meridian Meridian 1 Maintenance Manual

change linkctl

This command allows you to maintain entries within the link control file by
specifying a link to display information and then opting to delete the link,
leave it unchanged, or specify changes to it. The file name includes the
complete directory path to a link configuration file (which contains
parameter settings for the link). You can change the type of link going to
the host, but only TCP/IP, X.25, and HDLC are currently supported.
Command format:
mlusr> change linkctl
In the following example, only the host link (link 1) information is
changed to indicate that it uses HDLC rather than X.25 protocol.
Example:
mlusr> change linkctl
Current Control File Image
0
1
2
Current Entry > 0
Type :
Entry > <cr>
Current Entry > 1
Type :
Entry > 1
Current Entry > 2
Type :
Entry > <cr>
Meridian Link Release 5C/CCR Release 3C Diagnostic and Maintenance Guide
HDLC /usr/mlusr/conf/hdlcmlnk.datafile
X25 /usr/mlusr/conf/x25hlnk.datafile
ASYNC /usr/mlusr/conf/vlink.datafile
HDLC
"delete" to remove
"<ret>" to keep as is,
"<link number> <link type> <file name>" to change
X25
"delete" to remove
"<ret>" to keep as is,
"<link number> <link type> <file name>" to change
HDLC /usr/mlusr/conf/hdlchlnk.datafile
ASYNC
"delete" to remove
"<ret>" to keep as is,
"<link number> <link type> <file name>" to change
Ñ continued Ñ
Chapter 3: Link maintenance commands 97
/usr/mlusr/conf/hdlcmlnk.datafile
/usr/mlusr/conf/x25hlnk.datafile
/usr/mlusr/conf/vlink.datafile