Nortel Meridian Meridian 1 Maintenance Manual page 336

324 Chapter 7: CCR log file messages
553-3211-510 Standard 1.0 October 1998
2009
Log message
Cause 1, 2, 3, 4, or 5
Parameters
1: Bad message: missing or wrong information in the request
message
2: Meridian 1 link down: statistics changes required to complete
the installation cannot be requested
3: Time-out on requested statistics changes from Meridian 1
4: Request clash: another Variable Table was activated
5: Load failure: the call processing software could not successfully
load the Variable Table into memory
A Variable Table activation failed to complete. The
Description
previous version of the Variable Table remains active.
The new variables cannot be used in active call processing
Impact
until the problem has been corrected.
Recovery differs according to the cause, as follows:
Recovery
1: Software errorÑlog out and log back into the system, then retry
the activation.
2: The Variable Table activation requires changes in the statistics
information from Meridian 1. When the link is down, these
changes cannot be requested to complete the Variable Table
activation. Try again later when the link is up.
3: The Variable Table activation requires changes in the statistics
information from Meridian 1. No response to the requests was
received from Meridian 1. Check the link status and try again.
4: This is an attempt to activate more than one table at a time. Find
the log file entries for the activation underway and when it
completes, retry the activation.
5: Call processing was unable to activate the Variable Table,
possibly because of shared memory or other memory allocation
problems. Try again later or restart the application.
Variable Table activation failed