Nortel Meridian Meridian 1 Maintenance Manual page 121

Table 4
Link parameters (continued)
Link parameter
Internal address
Remote address
T1
Maximum out frames
(K)
Maximum trans
attempts (N2)
Local DTE address
Meridian Link Release 5C/CCR Release 3C Diagnostic and Maintenance Guide
Allowed values
(defaults in parentheses)
(1), 3
1, (3)
0Ð(30)Ð9999
1Ð(7)
1Ð(7)Ð9999
000000990100
Ñ continued Ñ
Chapter 3: Link maintenance commands 109
Description
1 for DCE; 3 for DTE
3 for DCE; 1 for DTE
Frame recovery time (in 1/10
second increments); must be
identical to the time specified on the
host computer configuration
LAPB window size; must be
identical to the size specified on the
host computer configuration
Maximum number of retries to
complete a transmission; must be
identical to the number specified on
the host computer configuration
Specifies the local DTE address of
the physical line
X.25 Òcall requestÓ address that
identifies the AM or IPE Module.
When the host sends the X.25 call
request packet to set up the SVC, it
must specify the local DTE address
of the AM or IPE Module. The
default value is Ò000000990100Ó.