Nortel Meridian Meridian 1 Maintenance Manual page 269

Table 7
maint messages that appear on the console (continued)
Command Message
view No files selected
No files available for selection
selectool: input file not found
selectool: out of memory
selectool: unknown error
<NUMBER>: exiting
viewlog SysLog file is not available
Meridian Link Release 5C/CCR Release 3C Diagnostic and Maintenance Guide
Chapter 5: Application Module and IPE Module error messages 257
Ñ end Ñ
Description
You have pressed [Return] without
selecting a file.
No files are available to be viewed.
The command which invoked the
selector is programmed incorrectly.
Report the failure to your Nortel
support personnel.
The selector cannot obtain enough
memory to function. Report the failure
to your Nortel support personnel.
A programmer error within the
selector causes an unknown error.
Report the failure to your Nortel
support personnel.
Note: <NUMBER> in the message
is replaced with the actual error
number generated.
The SysLog file was not available,
most likely because the file system
is too full. If this condition should
occur, all messages intended for the
SysLog file should be written to the
console. Use the diskuse command
to check the utilization of the hard
disk.