Nortel Meridian Meridian 1 Maintenance Manual page 45

Example:
maint> backfiles
(The screen clears and a list of files appears.)
1. /usr/maint/files/AMprofile
2. /usr/maint/files/AutoStart
3. /usr/maint/files/IncrDY
4. /usr/maint/files/IncrTM
5. /usr/maint/files/Port
6. /usr/maint/files/Prefs
7. /usr/maint/files/Speed
8. /usr/maint/logs/SysLog
9. /usr/maint/logs/SysLog.old
10. /usr/mlusr/conf/hdlchlnk.dataf
11. /usr/mlusr/conf/hdlcmlnk.dataf
12. /usr/mlusr/conf/lh.config
13. /usr/mlusr/conf/loop13DCE.d
14. /usr/mlusr/conf/loop13DTE.d
15. /usr/mlusr/conf/loop31DCE.d
16. /usr/mlusr/conf/loop31DTE.d
17. /usr/mlusr/conf/passthru.dat
18. /usr/mlusr/conf/tscfg.datafile
19. /usr/mlusr/conf/vlink.datafile
20. /usr/mlusr/conf/x25bcf333.2
21. /usr/mlusr/conf/x25hlink.datafi
Make a selection/deselection by entering the desired value: 1
Type the number corresponding to a file that you wish to back up (in this
example, item 1) and press [Return]. An asterisk (*) appears beside the
entry. You may continue selecting files by typing numbers and pressing
[Return]. When you have selected all the files you wish to back up, press
[Return] again. Your screen then lists the files to be backed up.
Assuming that you have selected item 1 only, the following appears:
Files to be backed up:
/usr/maint/files/AMprofile
Make sure tape is in the drive.
When ready, enter Ôy' to continue, or 'n' to quit: [y,n] n
##### No action taken.
maint>
Meridian Link Release 5C/CCR Release 3C Diagnostic and Maintenance Guide
Chapter 2: Application Module commands 33