Nortel Meridian Meridian 1 Maintenance Manual page 159
Application module and intelligent peripheral equipment module meridian link release 5c/ccr release 3c diagnostic and maintenance guide
Hide thumbs
Also See for Meridian Meridian 1:
- Feature description and administration (1816 pages) ,
- Scripting manual (812 pages) ,
- Upgrade manual (286 pages)
Table of Contents
Advertisement
Command format:
mlusr> loopback test
Example:
This command tests links 0 and 1.
mlusr> loopback test
Enter first Port/Link number (e.g. 0, 1, or ÔqÕ): 0
Enter second Port/Link number (e.g. 0, 1, or ÔqÕ): 1
Please plug in a straight cable between the ports
Ready (yes or no): y
Performing Loopback Test: Link 0 (DTE) and Link 1 (DCE)
Note: 0 and 1 are the port numbers that the user enters.
Configure Link 0 : successful
Configure Link 1 : successful
Enable Link 0 : successful
Enable Link 1 : successful
Loopback Test Successful
Note: If the link is not established, the following messages appears.
Loopback Test failed: reason ...
Restoring original link configuration
Please wait ...
Configure Link 0 : successful
Configure Link 1 : successful
Configure Link 2 : successful
Enable Link 0 : successful
Enable Link 1 : successful
Enable Link 2 : successful
mlusr>
Meridian Link Release 5C/CCR Release 3C Diagnostic and Maintenance Guide
Chapter 3: Link maintenance commands 147
- Quick Links:
- Logging in
Hide quick links:
Advertisement
Table of Contents
