Nortel Meridian Meridian 1 Maintenance Manual page 457

Procedure 22: Load the application software from tape (continued)
Figure 128
Meridian ID prompt
Please enter the Meridian 1 ID of this site:
(or Q or q to quit)
10 The system prompts you for the Meridian 1 ID. Type your ID and
press [Return].
Note: If you make a mistake while typing your Meridian 1 ID or
keycode, do not try to backspace and correct the error. Instead,
continue until step 16, where you will be able to type n, press
[Return], and return to step 10.
Note: Input for the Meridian 1 ID is case sensitive; input for the
keycode is not case sensitive.
Figure 129
Keycode prompt 1
Please enter your keycode (5 groups of 4 characters):
Keycode group 1 (or Q or q to quit):
11 The system prompts you for your keycode. Type the first 4-
character group of your keycode and press [Return].
Figure 130
Keycode prompt 2
Keycode group 2 (or Q or q to quit):
12 You are prompted for the second group of keycode characters.
Type the second group and press [Return].
Meridian Link Release 5C/CCR Release 3C Diagnostic and Maintenance Guide
Chapter 8: Recovery/replacement procedures 445