backdataÑback up data files
You can back up configuration files and data files to cassette tapes. All data
files can be loaded onto one data cassette tape. When inserting the tape into
the tape drive, check to make sure that the arrow printed on the face of the
cartridge is positioned toward the right side of the drive (as shown in
Figure 6) and the notch points down (as shown in Figure 7).
Ensure that the tape you leave in the tape drive is a backup tape, and
not a system tape with software on it. Ensure that the backup tape is
not write-protected.
Ensure you have the correct backup tape; the IPE Module uses a
600-Mbyte tape and the Application Module uses a 155-Mbyte tape.
Figure 6
Cassette tape with write protection disabled
Top view of tape
Meridian Link Release 5C/CCR Release 3C Diagnostic and Maintenance Guide
Chapter 2: Application Module commands 27
ATTENTION
ATTENTION
This side in
Write-enabled tab position
Front view of tape
(the front is the side with the
Meridian 1 software label)