Properties Of The Rs232 Interface - Siemens SIMATIC S7-1500/ET 200MP CM PtP RS232 HF Manual

Product overview

2.4 Properties of the RS232 interface

2.4 Properties of the RS232 interface
Definition
The RS232 interface is a voltage interface used for serial data transmission.
Properties
The RS232 interface has the following properties and meets the following requirements:
Type
Front connector
RS232 signals
Max. data transmission
rate
max. cable length
Standard
RS232 signals
The table below shows the meaning of the individual RS232 accompanying signals.
Table 2- 2 Signals of the RS232 interface
Signal Designation
TXD Transmit Data
RXD Receive Data
RTS Request To Send
CTS Clear To Send
DTR Data Terminal Ready
DSR Data Set Ready
RI Ring Indicator
DCD Data Carrier Detect
14
Voltage interface
9-pin sub-D male connector with screw lock
TXD, RXD, RTS, CTS, DTR, DSR, RI, DCD, GND; all signals isolated
against the backplane bus and load voltage
115.2 kbps
15 m, cable type LIYCY 9 x 0.14
DIN 66020, DIN 66259, EIA-RS 232C, CCITT V.24/V.28
Meaning
Transmit data; transmit cable logically held to "1" by communication module in idle
state.
Receive data; receive cable logically held to "1" by communication partner in idle state.
Request to send
RTS set to "ON": Communication module ready to send; signals to the communication
partner that there is data ready to send
RTS set to "OFF": Communication module not ready to send
Clear to send
CTS set to "ON": Signals "clear to send" to the communication partner
CTS set to "OFF": Signals "Not clear to send" to the communication partner
DTR set to "ON": Communications module switched on, ready for operation
DTR set to "OFF": Communications module not switched on, not ready for operation
DSR set to "ON": Communication partner signals "ready for operation"
DSR set to "OFF": Communication partner not switched on, not ready for operation
Incoming call when connecting a modem
Carrier signal when connecting a modem. The communication partner signals with a
high level that it detects incoming data on the cable.
CM PtP RS232 HF (6ES7541‑1AD00‑0AB0) communication module
Manual, 01/2013, A5E03790665-01