Keysight FieldFox B Series User Manual page 736

If your Markers are positioned and in Normal marker mode, no changes are
made to the Mkr1 through Mkr4 settings.
If your Markers are not previously positioned and in Normal marker mode,
when you select the Mkr5 and Mkr6 maximum and minimum setting, your
markers are set as follows:
— Markers are all set to
— Mkr1 and Mkr3 are set to 1/4 full span
— Mkr2 and Mkr4 are set to 3/4 full span
How to use the Mkr5 and Mkr6 markers to find maximums and minimums between your Normal
markers (CAT and NA Mode):
This section assumes you understand the previous marker features. And, that you have previously
positioned your markers (Mkr1 and Mkr2 or and Mkr3 and Mk4) and set the markers up as
markers using "How to create Markers" on page 726
example, if your markers are set to Delta, change to Normal, and verify the marker positions are
correct. Refer to Figure 30-6 on page
— Then press Mkr ->/Tools.
— Then More (For DTF, TDR measurements, and NA Mode, skip this step and proceed to the next
step.)
— Then Mkr5 & Mkr6 Search
— For Mkr1 & Mkr2 maximum or minimum value search:
— Then Mkr5 Peak
— Mkr5 Min
Or for Mkr3 & Mkr4 maximum or minimum value search:
— Then Mkr6 Peak
— Mkr6 Min
736
Data Analysis Features
All about Markers
Normal
737.
or
or
and other previous marker sections. For
Keysight N9938-90006 User's Guide
Normal