Keysight FieldFox B Series User Manual page 604

VVM (Vector Voltmeter) Mode - Option 308
VVM Mode Settings
VVM Mode Settings
Select VVM Mode before making any setting in this section.
How to select VVM Mode
— Press Mode
— Then
Measurement Selection
How to select a VVM Measurement
— Press Measure 1
— Then choose from the following:
Frequency Selection
How to set Frequency
— Press Freq/Dist
— Then
— Enter a value using the numeric keypad, the
— After using the
— After using the keypad, select a multiplier key. Learn about multiplier
Display Resolution
You can display either one digit or two digits after the decimal point for both
magnitude and phase readings.
604
VVM
— 1-Port Cable Trimming
make this measurement in
on page 609.
— 2-Port Transmission
to make this measurement in
on page 611.
— B/A and A/B 2-port ratioed receiver measurements using external
sources. Learn more in
Frequency
knob.
arrows or the rotary knob, press Enter. The increment
setting of the arrows is based on the current span and can NOT be changed
in VVM Mode.
abbreviations in"Multiplier Abbreviations" on page
1-port reflection measurement. Learn how to
"1-Port Cable Trimming Measurements "
2-port transmission measurement. Learn how
"2-Port Transmission Measurements"
"A/B and B/A Measurements" on page
Keysight N9938-90006 User's Guide
612.
arrows, or the rotary
46.