Keysight FieldFox B Series User Manual page 486

Indoor and Outdoor Mapping – Option 352 (Requires Spectrum Analyzer Mode (Option
233), and GPS Receiver (Option 307))
How to Set Up Mapping Settings
3. If you are using an antenna with your measurements, then Connect your
4. Then press Esc >
5. Set up indoor mapping press
486
equipment similar to Figure 14-1 on page 419
Prototype Phased Array Antenna – Option 360"
page 456 in Chapter 15, "USB Antennas – (Full Capability Requires EMF
Option 358, and either SA mode (Option 233 Mixed Analyzers) or OTA—5G
NR / 5G NR EVM Conducted Option
Back
only) > Data Logging to view the Data Logging softkeys and set the
Settings, Record Save/Recall, and
Signal Locate.
— For Outdoor Mapping:
System
— Default
— System
folder path/name:
Refer to
— Then File Type
— KML (default) or
— CSV
— Then Save Log File.
or
— Then Recall Log
— Optional Auto Save ON
power loss occurs.
— Then Back
choose
378)".
> Measure 1 or Trace 6 >
More > Indoor Map Data Logging
Record Save/Recall
– Sets the default User Folder path:
——List files (*.csv and *.kml) are save-recalled to:
"[CurrentDevice]:\RecordPlayback\CS\"
——Record-Play files are save-recalled to:
"[CurrentDevice]:\RecordPlayback\CS\"
Or
– Sets the User Folder to the user defined system
——List files are save to-from
"CurrentDevice\<UserSelectedFolder>\"
——Record-Play files are save-recalled to:
"CurrentDevice\<UserSelectedFolder>\"
"File Management" on page
File.
(default = OFF). To avoid loss of data, if
More > Indoor Map Data Logging
Keysight N9938-90006 User's Guide
in Chapter 14, "5G Rapid
or to Figure 15-1 on
More (required for OTA
Record
> File Folder Default
803.
then
or