Keysight FieldFox B Series User Manual page 130

Calibration for NA, CAT, and VVM Modes
1. S-parameters – Verify that these are all of the S-parameters that you want
2. DUT Connectors – For each DUT port that is shown, verify the correct type
3. Cal Kit - Verify the correct Cal Kit for each DUT port to be calibrated. See a
4. Calibration Type - The FieldFox always RECOMMENDS a Cal Type that will
Begin Calibration
130
calibrated. If not, press Esc to terminate the calibration process, then
return to the Trace menu to display all of the traces to be calibrated. Learn
how in "Multi-Trace Configurations" on page 95
and gender of the DUT connector. If a DUT port is not shown, then that
port is not included in the list of S-parameters to be calibrated.
list of supported Cal Kits in the FieldFox Data Sheet. Learn more in
Appendix B: "Specifications/Data Sheet," on page
If the DUT connector type, gender, or Cal Kit is NOT correct for the DUT
ports to be calibrated, then:
— Press Change DUT Connectors
that are on your DUT.
— For each port:
— Use the
connector type.
— Press Change Gender
connector.
— Then press
the process.
— For each port:
— Use the
that you have, and are going to use, for the specified ports.
— Press Next...
process.
— Then press
quickly and accurately calibrate all of the displayed S-parameters.
Change from the RECOMMENDED Cal Type ONLY if you understand the
implications. Learn more about Cal Types in
page 136.
To select a different Cal Type:
— Press Change Cal
— Then using the
— Then press Select and
to select the correct connector types
arrows or rotary knob to change the DUT
to change the gender of the DUT
Next... to confirm the selection and continue
arrows or rotary knob to select the Cal Kit
to confirm the selection and continue the
Finish to end the selection process.
"Calibration Type" on
Type.
arrows or rotary knob, select a Cal Type,
Finish.
Keysight N9938-90006 User's Guide
857.