Keysight FieldFox B Series User Manual page 246

SA (Spectrum Analyzer) Mode (Option 233–Mixed Analyzers)
Spectrum Emission Mask (SEM) — (SA Mode Only)
5. Setting the Detectors
246
The Trace menu shows that two Detector controls are available, one for
the Reference Channel (default Auto is Average to facilitate the Power
Integration), and another for all the Offset segments (default Auto is PEAK,
to facilitate finding PEAK signal energy when comparing against Limits).
There is only 1 Trace available, and like the other Channel Measurements,
it is set to average.
Press Trace 6 then
— State - sets the measurement state. Refer to
(SA Mode)" on page
— Default All - Sets the SEM settings to default
— Chan Detector - Sets the Reference Channel detector (default Auto
is Average to facilitate the Power Integration). See also
Method" on page
— Offset Detector
Peak, to facilitate finding peak signal energy when comparing
against the Limits). See also
— Record Playback
page 535.
201.
211.
- Sets all of the Offset segments (default Auto is
"Detection Method" on page
- Refer to "Record/Playback (SA Option)" on
Keysight N9938-90006 User's Guide
"Trace Display States
"Detection
211.