Keysight FieldFox B Series User Manual page 524

Remote Server Mode (Requires SA Hardware/SA Option 233)
In this Chapter:
FieldFox with a Remote Server mode (available with FieldFox firmware
≥A.10.00) does not display a mode softkey, because Remote Server mode
is only enabled when you have a SA Option 233 on the FieldFox,
compatible 89600 VSA software license loaded and running on a remote
PC, and connected via LAN to your FieldFox. (i.e., Requires 89600 VSA
software version ≥22.01).
When in Remote Server mode, most of the front panel hardkeys are locked
and will beep, but perform no actions when pressed (i.e., the FieldFox front
panel hardkeys are not relevant when connected via LAN to the 89600 VSA
software on your remote PC). In Remote Server mode only:
—
—
To gracefully disconnect (recommended) from the software, exit using the
PC-based software's disconnect option or shutdown the software. Refer to
"Initial Waiting for a Connection from a PC-based and Compatible
Licensed Software or No Remote Connection" on page
If you to attempt connect a non-compatible FieldFox you will see the
following error message:
"Error: 38, The requested functionality is not available."
In this Chapter:
"Connecting Using Remote Server" on page 525
"89600 VSA Software Overview (Requires N991xB/3xB/5xB/6xB and SA
Option 233)" on page 527
See Also
Optional Settings:
"LAN Settings" on page 793
"All about Markers" on page 726
"All about Limit Lines" on page 741
"All about Trace Math" on page 750
524
System 7 hardkey lets you change the system settings
Esc (escape) hardkey lets you forcefully disconnect from the PC-based
software
to
Refer : https://www.keysight.com/find/assist/
Keysight N9938-90006 User's Guide
.
525.