Scale - Keysight FieldFox B Series User Manual

Power Meter (USB/LAN) Mode - Option 302
USB and LAN Power Meter Settings
How to Set Source Control and Power Level
— Press Sweep 3 >
When Option 208 (FOPS) is enabled, to access Source Control, press
Sweep 3, then
Chapter 23, "Frequency Offset Using Power Sensor (FOPS) – Option 208",
on page 573
— Then
Optionally set the power level.
— Press
— Then enter a value using the numeric keypad, the
— Press Enter

Scale

The scale of the Power Meter display can be set manually or automatically. The
major and minor ticks are set automatically and can NOT be changed.
Although the scale settings are limited, you can view measurements beyond
these settings by performing Autoscale.
How to Scale the Power Meter Display
These softkeys are not available when Rx Power is enabled. See also
Power Measurements" on page
Manually:
— Press Scale / Amptd.
— Then choose from the following:
Autoscale:
Keysight N9938-90006 User's Guide
Advanced
Power Setup
.
Source Enable
— ON Turn ON the internal source
— OFF Turn OFF the internal source
Src Nom Power
arbitrary value at the displayed CW frequency.
knob.
— Scale Min Sets the low power level of the power meter display. Type
a number and select the units or press Enter. This value is limited to
–100 dBm.
— Scale Max Sets the high power level of the power meter display.
Type a number and select the units or press Enter. This value is
limited to 100 dBm.
Learn more about FOPS beginning on page
.
(-15 dBm default setting) Set output power to an
566.
arrows, or the rotary
"Source
565