Keysight FieldFox B Series User Manual page 757

System Settings
Preset
— Hold
—
How to perform a single sweep while in Hold
1. Press Sweep 3.
2. Then choose one of the following:
Preset
The Preset key restores the FieldFox measurement settings to a known
condition. You can preset the entire instrument, or just the current Mode (CAT,
SA, and so forth).
When Preset, the FieldFox CalReady calibration is recalled for use in CAT and
NA Modes. Learn more in
In addition to all Preference settings, the following settings always survive
Preset and Mode Preset:
— External Reference state (see
— SA Scale and Units (see
— SA Correction states (see
— VVM Display Resolution (see
— Marker Peak Excursion and Threshold (see
How to Preset the FieldFox
1. Press Preset.
2. Then choose one of the following:
Keysight N9938-90006 User's Guide
is displayed while a single sweep occurs.
— Single Automatically sets Continuous OFF (Hold) and causes
FieldFox to make ONE measurement sweep, then hold for the next
Single key press.
— SA Mode ONLY – With
press also causes a single sweep.
— Continuous ON OFF
setting when battery power is not critical.
"CalReady" on page
"Scale and Units" on page
— Preset Returns ALL Modes to the factory default settings.
— Mode Preset Returns only the current Mode to the factory default
settings. The current settings for all other Modes remain.
Continuous OFF each successive Run/Hold
Makes continuous sweeps. This is the typical
127.
"Frequency Reference Source" on page
"Field Strength Measurements" on page
"Display Resolution" on page
"What Is a 'Peak'" on page
789)
157)
161)
604)
737)
757