About The Auto-Range Feature - Keysight FieldFox B Series User Manual

Over–the–Air Measurements (OTA) – LTE FDD Option 370, LTE TDD Option 371, 5G TF
Option 377, 5G NR / 5G NR EVM Conducted Option 378

About the Auto-Range Feature

About the Auto-Range Feature
Executing an auto-range, which determines the optimal RF attenuation and
preamp settings for the current input signal.
See also,
Couplings: The current measurement settings help determine the auto-range
parameters. If more than one CC is enabled when an auto-range is executed,
the range is determined for each CC separately and the final range setting is
set using the maximum.
Executing an auto-range sets the Range, RF Attenuator, and Preamp
settings.
Executing an auto-range does NOT change any of the display settings (Ref
Level, Scale or Ref Pos).
Figure 13-33 OTA 5G NR Signal Before Auto-Range – Table
406
"OTA Setup Procedure" on page 359.
Keysight N9938-90006 User's Guide