Keysight FieldFox B Series User Manual page 512

Indoor and Outdoor Mapping – Option 352 (Requires Spectrum Analyzer Mode (Option
233), and GPS Receiver (Option 307))
Troubleshooting
— Then
If these are large recordings on a device, it could take several seconds for
the FieldFox to display the list.
end of the recording is reached, playback begins at the start of scan and
continues to loop indefinitely.
During playback, choose from the following:
—
—
—
—
—
Troubleshooting
This section contains the following:
—
512
Data Logging > Record Save/Recall
— Then Recall Log File
highlight the file to be played.
——Then Recall File
——Then Back
— Then Play to playback your Table data.
is displayed in the left of screen graticules during playback. When the
Pause Resume Temporarily halts playback. Then choose from the following:
— Pause Resume
Stop Immediately stops playback. Then choose from the following:
— Play Start playback from start of scan.
— Recall Log File Opens a list of stored data files.
Select a file to playback.
— Recall File
— Back
Cursor Position use this softkey to move the data log play cursor in the
current data log being played (i.e., Cursor Position is active only when
playback is paused).
This softkey is only available in Channel Scanner and Phased Array Antenna
modes (i.e., The Cursor Position softkey is not available for OTA mode).
Red Limit to edit the red limit dBm value.
Blue Limit to edit the blue limit dBm value.
"General Troubleshooting"
use the Use the RPG or the
Press to continue playing.
Keysight N9938-90006 User's Guide
arrow keys to