Keysight FieldFox B Series User Manual page 658

Channel Scanner (Option 312)
How to Set Up Channel Scanner
Figure 28-17 Yellow Trace with Cable and Antenna Corrections
Field Strength Measurements
Yellow Trace - Corrected trace with antenna factor. This correction, includes
the sum of the antenna correction and the cable correction (These corrections
are linearly interpolated). (Antenna = ON, Apply Corr = ON). Refer to
28-17 on page
For information, refer to
— Learn how to set Y-Axis Units on
— Use a Band Power marker to measure total power over a range of
How to select and edit corrections for Field Strength measurements
The Antenna and Cable correction data survives a Mode Preset and Preset.
All Correction ON/OFF states survive a Mode Preset, but NOT a Preset.
— Press Scale/Amptd.
— Then
— Then
— Then choose from the following:
658
658.
"Trace Display States (SA Mode)" on page 201
frequencies. Learn how in
More
Corrections
— Apply Corrections Auto Disabled
for all settings.
— RcvrSide Antenna Off / On
the receiver side.
— RcvrSide Cable Off / On
Receiver side.
Yellow trace:
Cable correction,
which is the sum
of the antenna
correction and
the cable
correction (These
corrections are
linearly
interpolated).
"How to Set Y-axis Units" on page
"Band/Interval Power Marker" on page 214
Use Auto and Disabled correction
Edit/Recall an Antenna file to be used on
Edit/Recall a Cable file to be used on the
Keysight N9938-90006 User's Guide
Figure
158.