Calibration Settings - Keysight N9912A User Manual

NA (Network Analyzer) Mode
NA Mode Settings
How to view and change Quick Settings
— Press Meas Setup 4.
— Then Settings.
— Press
are NOT available, then all available settings fit on one page.
— To change a setting:
— Press
the trace window. The Dock Window setting persists through a Preset.
Choose from the following:
When finished changing ALL settings, press

Calibration Settings

NA Mode has a page specifically for making settings that pertain to Port
Extensions, including Velocity Factor and Media Type.
Learn more in
Learn how to calibrate beginning in
page
The N9912A does NOT support Media Type: Waveguide.
How to view and change Calibration Settings
— Press Meas Setup 4.
— Then
— Make these settings in the same manner as Quick Settings in the previous
section.
5- 6
Next Page and Previous Page
—Use the arrows to highlight a setting.
—Then press Ed it. The current setting changes to yellow.
—Some settings require you to press a softkey to change the value.
Otherwise, use the numeric keypad,
change the value.
—When finished changing a value, press
Dock Window to relocate the Settings table to a position relative to
—Full (Default setting) Only the Settings table is shown on the screen.
The trace window is temporarily not shown.
—Left The Settings table is shown to the left of the trace window.
—Bottom The Settings table is shown below the trace window.
"Port Extensions" on page
7-2.
Calibration Settings.
to view all settings. If these softkeys
arrows, or rotary knob to
Done Edit.
Done to save your settings.
5-16.
"Why and When to Calibrate" on
Keysight N9912-90001 User's Guide