Keysight FieldFox B Series User Manual page 762

System Settings
Utilities
Utilities
FieldFox utilities settings will not survive a shut down. When your FieldFox is
turned OFF, then back ON, these settings default to their factory settings.
For information on the Phase Array Antenna and EMF Antennas softkeys,
refer to
360."
How to view and change Utilities Settings
— Press System 7
— Then
Utilities Softkey Choices
Then choose one of the following:
—
—
—
—
IMPORTANT!
The Frequency Extender (Freq Extnd) is only active (available) when one of
the following modes are enabled: SA/RTSA/IQA/OTA/PAA/VSA (via the
Remote Server feature).
When OML millimeterwave extenders are used, Cable and Antenna
corrections, if On, are included in eCorr, or Extended Corrections.
762
Chapter 14, "5G Rapid Prototype Phased Array Antenna – Option
and "USB Antennas" an
Utilities Opens the Utilities softkey menu.
Mapping – (Requires Option 352) opens a menu of softkeys that enables
the Indoor / Outdoor on–the–box mapping features. Refer to
"Indoor and Outdoor Mapping – Option 352 (Requires Spectrum Analyzer
Mode (Option 233), and GPS Receiver (Option 307))."
Phased Array Antenna
softkeys that enables the PAA measurements. Refer to
Rapid Prototype Phased Array Antenna – Option 360."
EMF Antennas – opens a menu of softkeys that enables the triaxial antenna
feature, for use in EMF measurements. Refer to
– (Full Capability Requires EMF Option 358, and either SA mode (Option
233 Mixed Analyzers) or OTA—5G NR / 5G NR EVM Conducted Option
378)."
Freq Extnd – opens a menu of softkeys that enables frequency extender
feature, for use with OML heads. Refer to
Frequency Extender (Freq Extnd) Settings" on page 763
Chapter 15.
(PAA – Requires Option 360) - opens a menu of
"How to view and change the
Keysight N9938-90006 User's Guide
Chapter 16,
Chapter 14, "5G
Chapter 15, "USB Antennas
.